With the development of science and technology, the degree of automation is increasing. From flame cutting to plasma cutting, laser cutting and other production techniques have been continuously promoted and popularized. And these efficient production technologies have also led to more and more serious pollution problems, resulting in more dust in the workplace. Dust remover is imperative before cutting technology is effectively promoted. The cutting gun on the cutting frame can be installed more, and the cutting ability and cutting thickness are continuously increased, more and more harmful smoke and gas produced by the flame. The efficiency of plasma cutting and the continuous increase of cutting thickness make the cutting smoke rising to a surprising extent. Laser cutting produces more subtle soot that is often overlooked, but that is more harmful to the human body. Choose a removal system with good dusting effect and low cost, it is not only the initial investment of the equipment, but also the stability and energy saving that the system runs. We can provide the most effective solution according to the actual situation of the customer, and minimize the harm of cutting smoke.
Flat laser cutting dust remover
The wind door type dust remover system adopts many technical innovations, Smoking effect is remarkable, installation and maintenance is simple, economic energy saving. Smoking effect is remarkable, installation and maintenance is simple, economic energy saving. The effect of cutting smoke absorption and purification depends on the design of the dust cutting table. In order to maximize the smoke absorption rate, the dust removal cutting table adopts modular design, no matter what your cutting range is, we can attain the size you need by modularity. The inside of the gantry cutting table is divided into separate zones for individual section vacuuming, each independent area has independent valve and it is controlled by cutting machine to automatically open the air valve in the area where the cutting is done to remove dust. Dust collecting boxes are installed in each suction area in the lower part to facilitate hoisting and dumping of dust.
The explosion-proof measures should be considered when cutting aluminum, magnesium and other alloy materials.
When cutting the grease workpiece, the dedusting equipment needs to increase the pretreatment device.
Variable frequency control can be used when the power of dust removal system is large